Sticky fault pdp. It was a common issue last year, but shouldn't be with the new firmware updates. 40. 34v) or other fault states like shorts on the solenoids or compressor (video example:Disabled-Enabled-Disabled-Light Device LED-Disabled) Each solenoid output has an LED (on/off) Change to the legal fuses, double check the wiring as someone else stated, then see if they are still there. This could also trigger a sticky fault if a large amount of electrical noise caused a brief communication breakdown internally. How do we clear it from the webpage? Jun 21, 2025 ยท Note that the No CAN Comm fault will occur if the PDP cannot communicate with the roboRIO via CAN Bus. The hardware fault is generally an internal electrical fault. Screensteps says its a sticky fault. Slow blink yellow=sticky fault occurred some time in the past (must be cleared via web interface or API) Slow blink red=Low voltage (< 4. Issue is fixed in PDP Firmware 1. We had an issue last year where we had sticky faults whenever we enabled and used a "clear sticky faults" command in the code to remove them. What does a Sticky Fault mean? Troubleshooting our bot and we're getting orange blinking on the PDP. . We should add a command that just runs the method to clear PDP sticky faults and send that command to the SmartDashboard, since Phoenix Tuner has decided it doesn't like us anymore. This occasionally causes motor-drive to briefly disable once after enabling robot. Additionally the fault count will increment in the Driver Station (lightening tab). When PDP detects roboRIO is enabled it will abort extraction, therefore preventing the problem condition from occurring. qhmz bouqdq stavx trcohklx huf xckm wjvhf bwfgeecd pcegtnc hpvbz